Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 No Lift - Tilt and motion fine
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="LazyKG" data-source="post: 101271" data-attributes="member: 12643"><p>Yep, the bolt sheered off at the top of the chain case. Great! _____ But I've got a plan to get this bugger working again. My neighbor will help me take the rops off with this skidloader and, if I can't rig a temporary pivot block to get the arms raised under power, I'll disconnect the arm hydraulic hoses and lift the arms with his loader. I plan to use an engine hoist with the hydraulic arm to lift the hydrostatic pump. _____ I do have one question, though. The service manual explains to disconnect the hoses from the pump; lots of work a very messy. Is it possible to lift the thing enough to get the chain case open and this pivot bolt replaced without taking the hoses all off and removing the pump completely? _____ If I really do need to take the hoses off, the manual says to use caps and plugs to keep the connections clean. Anyone know of a cost effective (aka cheap) source for these and what size it would take? _____ Thanks a lot, folks.</p></blockquote><p></p>
[QUOTE="LazyKG, post: 101271, member: 12643"] Yep, the bolt sheered off at the top of the chain case. Great! _____ But I've got a plan to get this bugger working again. My neighbor will help me take the rops off with this skidloader and, if I can't rig a temporary pivot block to get the arms raised under power, I'll disconnect the arm hydraulic hoses and lift the arms with his loader. I plan to use an engine hoist with the hydraulic arm to lift the hydrostatic pump. _____ I do have one question, though. The service manual explains to disconnect the hoses from the pump; lots of work a very messy. Is it possible to lift the thing enough to get the chain case open and this pivot bolt replaced without taking the hoses all off and removing the pump completely? _____ If I really do need to take the hoses off, the manual says to use caps and plugs to keep the connections clean. Anyone know of a cost effective (aka cheap) source for these and what size it would take? _____ Thanks a lot, folks. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 No Lift - Tilt and motion fine
Top