Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
731with F2L511 Black smoke problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="lecuyerb" data-source="post: 4220" data-attributes="member: 629"><p>Hi, First thanks for the reply. I primed the system with the bleed screw and again at the injector by cracking the lines open/closed per the manual. I have not had the level click ever - I always thought it was a manual primer/pump. I will check that next to make sure it is not stuck down but I am sure I pressed it a few times already. My fingers are crossed though. I am certain the aux is not engaged - that was my first hope - when I re attached the trencher I worked it forward and reverse before removing the trencher again. I have never pulled injectors and am not sure my manual covers that, it must, but just in case is there anything special to know? How do you test them when out? The noises were tough to separate out but I heard belt squeel, knocking (though I have never run it that high of RPM before so not sure if that would be normal). I don't know it the belt noise was from the high rpm and load from the pump that high or other but the knocking was more concerning. I have only run it maybe a total of three minutes since this started. The black smock is massive it clouds the whole area. Thanks again, Brian</p></blockquote><p></p>
[QUOTE="lecuyerb, post: 4220, member: 629"] Hi, First thanks for the reply. I primed the system with the bleed screw and again at the injector by cracking the lines open/closed per the manual. I have not had the level click ever - I always thought it was a manual primer/pump. I will check that next to make sure it is not stuck down but I am sure I pressed it a few times already. My fingers are crossed though. I am certain the aux is not engaged - that was my first hope - when I re attached the trencher I worked it forward and reverse before removing the trencher again. I have never pulled injectors and am not sure my manual covers that, it must, but just in case is there anything special to know? How do you test them when out? The noises were tough to separate out but I heard belt squeel, knocking (though I have never run it that high of RPM before so not sure if that would be normal). I don't know it the belt noise was from the high rpm and load from the pump that high or other but the knocking was more concerning. I have only run it maybe a total of three minutes since this started. The black smock is massive it clouds the whole area. Thanks again, Brian [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
731with F2L511 Black smoke problems
Top