Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642b oil leak
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 20054" data-attributes="member: 82"><p>So the oil is leaking out of the pintle arm? the shaft that comes out the side that connects to the steering levers?</p><p>There is no way you can move the arms too far, the rotating group limits the trvel. It depends on what pump you have if pre-load is an iuuse, i'm not sure what ones need the bearing pre-loaded as i think some just use taper bearings. That doesn't mean the bearings haven't worn and are allowing the shaft to move enough to allow oil to get past the seal.</p><p>The charge pressure sender should be on the back of the pump with one hose going to one side of a T piece that enters the top of the pump. This is assuming you have the newer style pump setup.</p></blockquote><p></p>
[QUOTE="Tazza, post: 20054, member: 82"] So the oil is leaking out of the pintle arm? the shaft that comes out the side that connects to the steering levers? There is no way you can move the arms too far, the rotating group limits the trvel. It depends on what pump you have if pre-load is an iuuse, i'm not sure what ones need the bearing pre-loaded as i think some just use taper bearings. That doesn't mean the bearings haven't worn and are allowing the shaft to move enough to allow oil to get past the seal. The charge pressure sender should be on the back of the pump with one hose going to one side of a T piece that enters the top of the pump. This is assuming you have the newer style pump setup. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642b oil leak
Top