Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642b No start, fuel issue...?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Atilathehun99" data-source="post: 122800" data-attributes="member: 1757"><p>Different engine but I had the same problem w/ my 722. Would run for a while and die. Let sit, rinse and repeat.</p><p></p><p>Everyone had ideas but not one was a solution. Finally in desperation I was going to send my distributor in for a re-build. When I told the guy it was a Bosch out of a Ford 1.6 L industrial he said don't waste my money or his time. According to him Ford cheaped out and didn't spend the extra $$ to have Bosch case harden the distributor's shaft.</p><p></p><p>Made sense to me. Everything fine until the block heats up and expands ever so slightly, but enough to create an oversized hole for the distributor shaft. That then can wobble a tiny bit throwing off the points gap.</p><p></p><p>Can't say for sure if that was the problem but after putting in a new Pertronix distributor the problem ceased and never has occurred again.</p><p></p><p>I know the 642B has a Mits engine but I'm just sharing my experience.</p></blockquote><p></p>
[QUOTE="Atilathehun99, post: 122800, member: 1757"] Different engine but I had the same problem w/ my 722. Would run for a while and die. Let sit, rinse and repeat. Everyone had ideas but not one was a solution. Finally in desperation I was going to send my distributor in for a re-build. When I told the guy it was a Bosch out of a Ford 1.6 L industrial he said don't waste my money or his time. According to him Ford cheaped out and didn't spend the extra $$ to have Bosch case harden the distributor's shaft. Made sense to me. Everything fine until the block heats up and expands ever so slightly, but enough to create an oversized hole for the distributor shaft. That then can wobble a tiny bit throwing off the points gap. Can't say for sure if that was the problem but after putting in a new Pertronix distributor the problem ceased and never has occurred again. I know the 642B has a Mits engine but I'm just sharing my experience. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
642b No start, fuel issue...?
Top
