Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
542B Distributor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Lingle" data-source="post: 130359" data-attributes="member: 24024"><p>So a few years ago the 542B with the Ford 4 cylinder industrial engine my in-laws have had the float/shutoff in the carb stick, flooding out the intake and dropping onto the ignition coil(which is mounted in a terrible place under the air filter), causing a fire. after rewiring the damaged wires and replacing the ignition module, this version of engine has the solid state ignition module mounted on the distributor, I still do not get spark. I have not checked, per the manual, the resistance of the internal distributor components, but I speculate there is something wrong there since I replaced the module and coil, there is 12V and good ground at the module. are there other things to check for why I dont get spark? I have good power wires(new), good ground, etc.</p><p></p><p>I have 2 request I am hoping this forum can help with:</p><p></p><p>1. does anyone have recommendation on where to get a new/used distributor? PN would be 86BF-12100-BA or 86BF-12100-FA</p><p>2. recommendation on the fuel shutoff solenoid on the carburetor(side draft version)?</p></blockquote><p></p>
[QUOTE="Lingle, post: 130359, member: 24024"] So a few years ago the 542B with the Ford 4 cylinder industrial engine my in-laws have had the float/shutoff in the carb stick, flooding out the intake and dropping onto the ignition coil(which is mounted in a terrible place under the air filter), causing a fire. after rewiring the damaged wires and replacing the ignition module, this version of engine has the solid state ignition module mounted on the distributor, I still do not get spark. I have not checked, per the manual, the resistance of the internal distributor components, but I speculate there is something wrong there since I replaced the module and coil, there is 12V and good ground at the module. are there other things to check for why I dont get spark? I have good power wires(new), good ground, etc. I have 2 request I am hoping this forum can help with: 1. does anyone have recommendation on where to get a new/used distributor? PN would be 86BF-12100-BA or 86BF-12100-FA 2. recommendation on the fuel shutoff solenoid on the carburetor(side draft version)? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
542B Distributor
Top