Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Discussion Forums
General Chit Chat
2015 Bobcat S650 going into limp mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="tapline" data-source="post: 127109" data-attributes="member: 23333"><p>Thanks for the reply cdmccul. It is surely dusty here and deceiving since the grass is green and lush but about an inch below the roots, you hit nothing but soft dirt and dust. I cleaned out the filter and then decided to replace it with a new one. I also took off the tubes on the right and left side of the air box and looked all the way in each to ensure there were no leaves or debris. On the right side of the box and all the way to the engine intake it is clear. It looks like a type of map sensor in there so I gently air blew that out but no dust came out so I'm assuming its fine. I thoroughly cleaned the engine bay just to be sure no debris or dust was building up enough to fill any air opening needed but when I started the machine, it now starts with that code immediately and stays in limp mode. the engine sounds fine and it only slightly increases in power as I rotate the engine speed knob but nowhere near it powered up prior to this issue. Is there some other type of air filter Im missing that would cause this issue?</p></blockquote><p></p>
[QUOTE="tapline, post: 127109, member: 23333"] Thanks for the reply cdmccul. It is surely dusty here and deceiving since the grass is green and lush but about an inch below the roots, you hit nothing but soft dirt and dust. I cleaned out the filter and then decided to replace it with a new one. I also took off the tubes on the right and left side of the air box and looked all the way in each to ensure there were no leaves or debris. On the right side of the box and all the way to the engine intake it is clear. It looks like a type of map sensor in there so I gently air blew that out but no dust came out so I'm assuming its fine. I thoroughly cleaned the engine bay just to be sure no debris or dust was building up enough to fill any air opening needed but when I started the machine, it now starts with that code immediately and stays in limp mode. the engine sounds fine and it only slightly increases in power as I rotate the engine speed knob but nowhere near it powered up prior to this issue. Is there some other type of air filter Im missing that would cause this issue? [/QUOTE]
Verification
Post reply
Forums
General Discussion Forums
General Chit Chat
2015 Bobcat S650 going into limp mode
Top