Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
2011 L218 codes 1203 and 3029
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="RDLDRDLD" data-source="post: 132483" data-attributes="member: 22525"><p>While I was moving snow the skid started intermittently running at low RPMs. Now it will start and sputter around 100 to 400 RPM for a few seconds and quit. The 3029 code says the oil pressure sensor is shorted and I replaced it. The 1203 code is for RPM sensor. </p><p>I heated everything up and same issue. If I let it set for a while, it will run a few more seconds than if I start it back to back.</p><p>I don't know if the errors are causing the problem or if they are a result of it not getting to the operating RPM it is expecting.</p><p>I will replace the 3rd filter, by the engine. I am looking for any info on these errors. The service manual is pretty vague. If someone has the wiring diagram and location of the RPM sensor it would be much appreciated.</p><p>I will call the dealer to see what they say, Monday.</p><p></p><p>Replaced oil filter, 2 of the 3 fuel filters, oil pressure sensor.</p></blockquote><p></p>
[QUOTE="RDLDRDLD, post: 132483, member: 22525"] While I was moving snow the skid started intermittently running at low RPMs. Now it will start and sputter around 100 to 400 RPM for a few seconds and quit. The 3029 code says the oil pressure sensor is shorted and I replaced it. The 1203 code is for RPM sensor. I heated everything up and same issue. If I let it set for a while, it will run a few more seconds than if I start it back to back. I don't know if the errors are causing the problem or if they are a result of it not getting to the operating RPM it is expecting. I will replace the 3rd filter, by the engine. I am looking for any info on these errors. The service manual is pretty vague. If someone has the wiring diagram and location of the RPM sensor it would be much appreciated. I will call the dealer to see what they say, Monday. Replaced oil filter, 2 of the 3 fuel filters, oil pressure sensor. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
2011 L218 codes 1203 and 3029
Top