Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Thomas Skidsteer Forum
Thomas 173HL II, stalled and will not start.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="BigOlThomas" data-source="post: 101548" data-attributes="member: 15682"><p>Hi , I had a similar frustrating experience last week, very happy to get the T173 going again. 1 - Make sure Diesel tank has enough fuel 2 - Bleed air from the fuel filter (you will find a screw at the top of the filter that you need to loosen to get the air out . Be sure to remember to tighten the screw after bleeding the air out. 3 -see if you can buy a rubber bulb fuel primer and install it on the line from the fuel filter to the fuel pump part of the line. 4 with the injectors loosened, squeeze the rubber bulb fuel primer until the bulb was hard to squeeze with the hand. This will force the air through the injectors, then tighten the injectors. The machine should start after this. https://www.google.ca/search?q=rubber+bulb+fuel+primer&rlz=1C1QJDA_enCA764CA764&source=lnms&tbm=isch&sa=X&ved=0ahUKEwiV2omsnJzXAhWL6YMKHaQuCp0Q_AUICigB&biw=1366&bih=637&safe=active&ssui=on</p></blockquote><p></p>
[QUOTE="BigOlThomas, post: 101548, member: 15682"] Hi , I had a similar frustrating experience last week, very happy to get the T173 going again. 1 - Make sure Diesel tank has enough fuel 2 - Bleed air from the fuel filter (you will find a screw at the top of the filter that you need to loosen to get the air out . Be sure to remember to tighten the screw after bleeding the air out. 3 -see if you can buy a rubber bulb fuel primer and install it on the line from the fuel filter to the fuel pump part of the line. 4 with the injectors loosened, squeeze the rubber bulb fuel primer until the bulb was hard to squeeze with the hand. This will force the air through the injectors, then tighten the injectors. The machine should start after this. https://www.google.ca/search?q=rubber+bulb+fuel+primer&rlz=1C1QJDA_enCA764CA764&source=lnms&tbm=isch&sa=X&ved=0ahUKEwiV2omsnJzXAhWL6YMKHaQuCp0Q_AUICigB&biw=1366&bih=637&safe=active&ssui=on [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Thomas Skidsteer Forum
Thomas 173HL II, stalled and will not start.
Top