Gathering ideas/thoughts for making pallet fork extensions for my skid steer. The intended use will not be very heavy but is needed for balance. I have many shooting houses on my hunting lease that need to be moved from time to time. They are mostly 6ft by 6 ft 6 inches. My forks are 40 inches. Extending them to make 7 ft would allow me to move them without having to run a long strap around the house and back of fork frame. I'm thinking of something like a 6 in "C" channel with a 4" plate welded at the back, bobcat side and another at the end fork length, 40". No need in cutting down the tip end because I can lift the houses a few inches and put a brick or something under the corner. Anybody built these before? What would you do different?