LX 885 No power to instrument cluster

[ESDTruck]

I have an LX 885 that won't start. Cranks fine and starts with key switch in start position, will not run with switch in run position. No lights come on instrument cluster when you sit on the seat. I just replaced the seat switch with no change. Checked fuses in cab and they were all good. What else could be causing this problem? Pulled machine in garage and everything was good and then went to start it an hour later and had this problem. The key switch is good also.

 

[Mike10]

When you sit in the seat the lights should light up if you have power to the seat switch. The power comes from the 5 amp fuse in the engine compartment. Unless you have the service/run switch in the service position or the fuse is blown the lights will come on when you sit in the seat. Check that the service/run switch is in the run position. The engine should not crank if there is no power at the seat switch with the service/run switch in the run position.
Check the 5 amp fuse in the engine compartment fuse panel. The fuse panel is on the left side of the engine compartment right behind the starter. Remove the cover and you will see two fuse banks. The 5 amp fuse you are looking for is in the right bank the second from the bottom.

 

[mhs1492]

Howdy. Did you ever figure this issue out? I have the same problem. Thanks