intermittent auxiliary hyrdaulics

[Curtmaurer]

I have a Gehl CTL85 which is the same as a Takeuchi TL250 and Mustang MTL325 that the auxiliary hydraulics will work for a little bit then they quit, all other hydraulics will continue to work normally, if you raise the lap bar up then back down they will work again for a little while then quit. Any help would be greatly appreciated!

 

[walio123]

This is an electrical problem. It may be lap bar switch , solenoid/s of aux. hydraulic ,relay or bad wire.

 

[Curtmaurer]

This is an electrical problem. It may be lap bar switch , solenoid/s of aux. hydraulic ,relay or bad wire.

I have tried swapping relays out and spent many hours looking for bad wire and connections.. It will almost always act up if I do anything located on the right joystick, loader arm, bucket or float, then I have to lower the arm back down all the way lift up the lap bar then back down and aux works again for a bit.