Recent content by Slave

Hey, so after taking the cylinder apart I found it did not even have a seal on the piston at all. The hydraulic shop had the parts and gave me the info on heating up the seal in oil before putting it on the piston then hose clamp it for a bit. Works perfect, yahoo.

the aux was stuck i believe from not being used. if you open the cage and look at the pivot point of the right stick you will see the rod going back to the valve body. i had a scrap of 1/2"x3' steel rod that went from outside through the boot and centered it on that connecting rod and had...

ok u-joints and chain fluid, the chain fluid sounds easy, ill get a cooler ready when i go after the u-joint, i did tip the cab when the quick coupler aux didnt work my buddy didnt have any implements so that valve didnt move for fifteen years with only a bucket, i tapped it with a rod and...

The bucket moves normally up and down but bleeds quickly down and dumps. Is it only possible this is the cylinder or could it possibly be bypassing through the valve and is there an adjustment? also the machine creeps forward when at an idle can that be adjusted or is that what the brake is...

Thanx for the info I pulled the four bolts off the manual fuel cutoff and pushed the lever back with a screw driver and some juicy spray and worked it a bit and it sounds smooth when running. I got lucky. not knowing bobcats other than complete fluid and filter change with a lube job at 3800...

the last time i pulled an injector pump was on a case backhoe years ago. i remember rolling it over to tdc on #1 for correct fuel timing when i put the rebuilt pump back in. I would like to know a good place to look for a shop manual or look at some pictures online, thank you for the help

did i post this in the right place and was that too much info

Hey Im new to the bobcat and this site, would appreciate any help. 743 sat for 7 yrs i did not drain the fuel maybe should have but added 5 gal of fresh with conditioner. pumped the bulb and fuel goes to bypass back to tank. pulled the rubber fuel line off the pump and it pulses but does not...

the fuel cutoff is a lever on top of the injector pump with a cable back to a knob in the cab you pull to cutoff the fuel right?

I pulled a 743 out of the woods it has a Kubota v1702 the fuel gets past the pump with the primer bulb and cranking with the fuel pump but not to the injectors even with the solid line to it completely removed. The fuel cutoff moves freely at the pump. The priming bulb moves fuel through the...