Recent content by mhs1492

I'm in Indiana and my 97' lx565 stays outside year round. After sitting most of the winter I started it and let it warm up. After just a few minutes of use the trans/hyd temp light and the trans charge pressure light both lit up and the machine died. I climbed out to investigate and noticed a...

Hey thanks, and I get the safety point. I have a new seat harness that I am trying to use. I cut the connector plug off that it plugs in to because it was broken. So now I will cut off the connector from the new seat harness and splice them together. At that connection I believe that it is...

I ran a new wire from the 5A fuse to pin #14 and the EIC lit up and did the preheat. so some success there, thanks. Now I need to figure out how the seat harness wires up. As I said before the main connectors for the seat harness are broken. The harness connector on the main harness side has...

I do have power at all times at pin 14, but only 2.5v. I' thinking it should be 12v, correct? I'll check the wires at the fuse block. My seat connector only has 4 wires. When I first got the machine many years ago, the terminals on the seat switches broke so I wired them to a rocker switch and...

I have also replaced the start interlock relay and still no dash lights. I just posted the following on a different thread but It may do some good here as well. Mike 10 I hope you read this. I have a LX565 with the gold trim gauge bezel. My EIC doesn't light up at all... just a constant beep...

Mike 10 I hope you read this. I have a LX565 with the gold trim gauge bezel. My EIC doesn't light up at all... just a constant beep. Going by your directions in a previous post, I checked the pins with the meter. First off, I discovered that the seat and seat belt switch harness had a broken pin...

Howdy. Did you ever figure this issue out? I have the same problem. Thanks

Thanks for the info. I just replaced that relay and it did fix the starter winding problem. However that relay is not the start interlock relay 86521256. You mentioned start interlock relay in you earlier post. Do you happen to know the function of this relay? So after replacing the start relay...

Howdy, I have been having start/run issues and have wondered if the start interlock relay could be to blame. can you share the issues you had when it went bad? What is the actual function of this relay? This should be a link to my thread..if I can paste on here...

So here's an update....After checking the starter for proper function (I assume) I put it back on and I put on a new start relay. Now I have no dash panel lights at all. It will still only start and run with the key held in the start position. However, now when I let go and the key is in the run...

I suspected that so I pulled the starter. I checked it with jumper cables. I energized the solenoid and the bendix engaged. Then I jumped the solenoid contact over to the large terminal on the starter and the gear spun. I assume that is proper function? At this point I feel that the start...

My LX565 has issues.... I went to start it after it was unused for several months. The gauges lit up, the pre-heat counted down, and then I turned the key. Click--Dead Battery. So I charged it for a few hours. Went to start it again and.... The gauges flashed for a split second and went dark. I...