Recent content by HighFly27

Help Support SkidSteer Forum:

  1. H

    CASE 1838 Diesel Lurches Forward or Back when Starting, Why ?

    24 Oct., 2018 Hello All, My Case 1838 is Driving Forward or Rearward when I'm trying to Start It. The Safety Bar is Down and the Machine Should be in the Lock Out Position... and No Movement at All. If I apply slight pressure on the control levers (fore or aft) then, the lurching movement is...
  2. H

    Advice on Idea to use a Snow Plow Sys. for Aux on Grapple Cyl.

    Response, Yep, I could tap into the output of the 1838 main pump. I just got the Case 1838 and have not looked at the hydraulic system (yet). -------------- I brought up the Snow Plow because it's brand new and I own it. I understand the fact that the plow lift cyl. is single acting. -----------...
  3. H

    Less expensive parts for case

    Hello Sir: I have a 1830 skid steer. My machine has the (4) Cyl. gas Renault engine in it. It's a pain and is/ was very expensive to buy parts for. I found all my Ignition parts at NAPA. I found a carb. rebuilt kit for it at a local tractor parts store. A new carb. from Case was around $ 600.00...
  4. H

    Advice on Idea to use a Snow Plow Sys. for Aux on Grapple Cyl.

    Hello All, 1. I just bought a used (1998 ?) Case 1838 skid steer. I'm in the process of doing a full service (repack lift cyl., repair rusted bucket, etc.) and other required checks/ adjustments. 2. I bought the 1838 to move some dirt that has build up behind in a ditch behind a 70 L. x 50 W...
  5. H

    Movement & Grinding Noise During Engine Start on Case 1838

    Hello All, I just bought a (1998 ?) Case 1838 a few days ago. I just started to check the 1838 out and do a full service. The hours are around 3,2XX, appears to be in -- fair to good shape, it runs A Ok; but I have not used it for more than 30 minutes (so far). It has a (4) cyl. Kubota diesel &...
See more
Top