Recent content by CurtWPk

"I'd put it above the radiator if it were mine, less prone to getting hit" I considered that. But I couldn't find a place to carry a step ladder.

X I finally figured out the forumula to post a picture.

After wishing I could carry stuff for a couple years, I finally fabricated a workable box for carrying chainsaw, chains etc. I use often my SS for forest work so having a way to carry the logging stuff is really important This has one vulnerability of course. If you back into something you break...

No. Even at slower engine speeds its too jerky for me. I have a lot of experience with skid loaders, excavators, articulating loaders etc. I have never had controls that are this hard to control. I wonder if its just "normal" for the M series. I hope not, because I need a fix. I got the manual...

I have a new S590 that replaced my G series 773T. The boom and bucket controls are waaay more sensitive than my 773. If for example, I have some load in the bucket, it is almost impossible to raise the boom a small amount like 1 inch. Instead, as soon as it moves, it goes so fast that it jumps...

I should have mentioned that. No. there are no codes.

When I start the engine, then press the "green button", the AHC fail light comes on and the boom/buck controls dont work. Never had this problem before. But... if I turn the key on, then press the green button, THEN start the engine, it works fine. When I press the button there is a slight delay...