Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Sources for High pressure hydraulic filter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 2388" data-attributes="member: 307"><p>I have one on my log slasher, right in the pressure line between the vickers pump and the volvo motor that runs the saw. Previous owner said it is there to protect the motor and the pump would go over relief if it plugged. (no bypass) Its a canister type filter, not a spin on, canister must be 3/8 thick wall steel. Other then filters being pricy ($60 usd) it has given no trouble. Flows @40 gpm at 2500psi. Spins a 60" saw at 1500 rpm, cross cut through 15 trees in a second or so. I'd like one for my brusher, as a renter wiped the motor out this past season, (ran 50 feet and seized, hyd shop said dirty quick couplers, makes sense, long enough for dirt to get to motor) Local hyd shop said these filters are about $1000 cdn. Motor was only $450 I realize most filters are a low press return filter, just because they cost alot less to make. But hi press are available, if I can find a resonable priced source. Also hyd bobcat filters must be a higher press (not 2500 psi though) as they are quite heavy too. Do they run at charge press?? Thanks for the help. Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 2388, member: 307"] I have one on my log slasher, right in the pressure line between the vickers pump and the volvo motor that runs the saw. Previous owner said it is there to protect the motor and the pump would go over relief if it plugged. (no bypass) Its a canister type filter, not a spin on, canister must be 3/8 thick wall steel. Other then filters being pricy ($60 usd) it has given no trouble. Flows @40 gpm at 2500psi. Spins a 60" saw at 1500 rpm, cross cut through 15 trees in a second or so. I'd like one for my brusher, as a renter wiped the motor out this past season, (ran 50 feet and seized, hyd shop said dirty quick couplers, makes sense, long enough for dirt to get to motor) Local hyd shop said these filters are about $1000 cdn. Motor was only $450 I realize most filters are a low press return filter, just because they cost alot less to make. But hi press are available, if I can find a resonable priced source. Also hyd bobcat filters must be a higher press (not 2500 psi though) as they are quite heavy too. Do they run at charge press?? Thanks for the help. Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Sources for High pressure hydraulic filter
Top