Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
replacing axle seal on bobcat S130
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="farmboy55" data-source="post: 6150" data-attributes="member: 536"><p>Hey Danvil, Where are you located?? I made a puller, took a peice of 1" x 3" flat stock and drill a 1" finetread hole in the center for a grade 8 bolt, then two on a 8" center for the lug bolt holes, I had to put a plate on each side of the flat stock to beef it up (it bent in the center the first time) used a big impact wrench & radchet with cheater pipe, get it as tight as you dare, then stand to the side and put the hammer to it. Ihad one to fly off when it came loose. I have access to a machine shop so there was no cost to making the puller. It takes a big heavy duty puller to do the job. I've yet too have one that came off easy. dennis</p></blockquote><p></p>
[QUOTE="farmboy55, post: 6150, member: 536"] Hey Danvil, Where are you located?? I made a puller, took a peice of 1" x 3" flat stock and drill a 1" finetread hole in the center for a grade 8 bolt, then two on a 8" center for the lug bolt holes, I had to put a plate on each side of the flat stock to beef it up (it bent in the center the first time) used a big impact wrench & radchet with cheater pipe, get it as tight as you dare, then stand to the side and put the hammer to it. Ihad one to fly off when it came loose. I have access to a machine shop so there was no cost to making the puller. It takes a big heavy duty puller to do the job. I've yet too have one that came off easy. dennis [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
replacing axle seal on bobcat S130
Top