Hey guys, the steering lever broke on my Bobcat 753. I bought a replacement lever and when I went to replace it, I was not able to get my open end box wrench onto the nuts that hold the steering lever in place. This was in part because there is a point where all of the hydraulic lines meet up, which can be seen in (picture 2) making it near impossible to get my tools in there. So, do I need a specific tool the will allow me to access the nuts without have to remove the hydraulic lines and the object that they go into. Sorry to post the pictures this way guys, I have a Mac and I can't figure out any other way to do it.