Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Rear axle seals and bearings 743
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 7669" data-attributes="member: 82"><p>I took pictures of it. I tried to do battle with the pictures section of the forum but it refuses to work for me so they are at: <a href="http://users.tpg.com.au/tazza_/2007_06_09/" target="_blank">http://users.tpg.com.au/tazza_/2007_06_09/</a></p><p>Most of the sizes are not critical, you can be a bit out and it will still work fine. I used a hose clamp to hold the 2 pieces together unlike the original that used a spring that i found didn't work well, thats the groove on the outside. You don't need it if you use a hose clamp, thats why sizes are not listed for it.</p><p>Hopefully i got sizes for everything else but if not just yell.</p><p>The way i did it was to machine to to rough size and cut it in half, then put it back in the lathe to finish it off so both halves separated correctly and are round.</p><p>If anything isn't clear just yell.</p></blockquote><p></p>
[QUOTE="Tazza, post: 7669, member: 82"] I took pictures of it. I tried to do battle with the pictures section of the forum but it refuses to work for me so they are at: [URL]http://users.tpg.com.au/tazza_/2007_06_09/[/URL] Most of the sizes are not critical, you can be a bit out and it will still work fine. I used a hose clamp to hold the 2 pieces together unlike the original that used a spring that i found didn't work well, thats the groove on the outside. You don't need it if you use a hose clamp, thats why sizes are not listed for it. Hopefully i got sizes for everything else but if not just yell. The way i did it was to machine to to rough size and cut it in half, then put it back in the lathe to finish it off so both halves separated correctly and are round. If anything isn't clear just yell. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Rear axle seals and bearings 743
Top