Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
873 locks up when moving
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 6612" data-attributes="member: 782"><p>Yes the clamp will hold the white plunger in the postion so that the magnet will activate , the spring force is very minimal , it almost takes two people to do it on the machine as you have to push down on the seat with the cab open while you postion and tighten the clamp , like I mentioned it is a little easier to take the sensor off the bottom of the cab , clamp it then tape and strap it up out the way ------the kit they sell has a new controller box , push to operate switch and a new operator manuel that straps behind the seat , it cost around $200 US and takes about 20 minutes to install --------a slim jim like they use to open lock doors on cars and a garden hose will sometimes clear any dirt from under the seat plate which is usually the problem of way the seat sensor doesn't activate , and thats no bull , fishfiles</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 6612, member: 782"] Yes the clamp will hold the white plunger in the postion so that the magnet will activate , the spring force is very minimal , it almost takes two people to do it on the machine as you have to push down on the seat with the cab open while you postion and tighten the clamp , like I mentioned it is a little easier to take the sensor off the bottom of the cab , clamp it then tape and strap it up out the way ------the kit they sell has a new controller box , push to operate switch and a new operator manuel that straps behind the seat , it cost around $200 US and takes about 20 minutes to install --------a slim jim like they use to open lock doors on cars and a garden hose will sometimes clear any dirt from under the seat plate which is usually the problem of way the seat sensor doesn't activate , and thats no bull , fishfiles [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
873 locks up when moving
Top