Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 hydraulic controll valve
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidboy" data-source="post: 6350" data-attributes="member: 719"><p>All you need todo is undo the end cap (leave the C clip and washer attached ) Pull the end cap off slowly and the 2 balls and spring will still be captive in the cap.Use a 3/16 allan key and undo the spring retainer.Hold some pressure on the retainer so it doesnt hit you in the gob.Take the spring,washer etc off.Use a pick and remove the old seal (be careful not to scratch the sealing area of either the spool or housing.The only trickey bit is replacing the outer set of ball and spring.Bobcat use to sell a special tool (its C shaped and it fits over the hole in the spring retainer.You feed a ball,spring,ball through a hole in the tool,fit a screw in to the tool ,which compresses the balls together and you simply push the inner cap over thspring retainer.It sounds complicated but its about a 20 min. job in total, and no loss of oil.</p></blockquote><p></p>
[QUOTE="skidboy, post: 6350, member: 719"] All you need todo is undo the end cap (leave the C clip and washer attached ) Pull the end cap off slowly and the 2 balls and spring will still be captive in the cap.Use a 3/16 allan key and undo the spring retainer.Hold some pressure on the retainer so it doesnt hit you in the gob.Take the spring,washer etc off.Use a pick and remove the old seal (be careful not to scratch the sealing area of either the spool or housing.The only trickey bit is replacing the outer set of ball and spring.Bobcat use to sell a special tool (its C shaped and it fits over the hole in the spring retainer.You feed a ball,spring,ball through a hole in the tool,fit a screw in to the tool ,which compresses the balls together and you simply push the inner cap over thspring retainer.It sounds complicated but its about a 20 min. job in total, and no loss of oil. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 hydraulic controll valve
Top