Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Starting problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="GILL" data-source="post: 1772" data-attributes="member: 265"><p>It's supposed to get to 30 deg. tomorrow, if I get carb back together, tomorrow I think I'll put new plugs in, reinstall carb, and try heating engine with propane torpedo heater. I will check timing using your info plus manual's pics, etc. Have a friend with 25 yrs exp. as a car mechanic on call if needed. Latest problem is getting seat out of carb. It does not want to budge, soaked it with PB blaster last nite and will try grinding a 5/8 bolt to a screwdriver tip to get a better bite on it. People tell me to invert carb and check float measurement, should be about 1-1/8 from gasket surface to bottom of float. Thanks Greg</p></blockquote><p></p>
[QUOTE="GILL, post: 1772, member: 265"] It's supposed to get to 30 deg. tomorrow, if I get carb back together, tomorrow I think I'll put new plugs in, reinstall carb, and try heating engine with propane torpedo heater. I will check timing using your info plus manual's pics, etc. Have a friend with 25 yrs exp. as a car mechanic on call if needed. Latest problem is getting seat out of carb. It does not want to budge, soaked it with PB blaster last nite and will try grinding a 5/8 bolt to a screwdriver tip to get a better bite on it. People tell me to invert carb and check float measurement, should be about 1-1/8 from gasket surface to bottom of float. Thanks Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Starting problems
Top