You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support SkidSteer Forum:
-
Y
ymurf replied to the thread
1980 Bobcat 530.
mine is the 533. Same as yours except diesel. Had to rebuild mine. Costs allot more than the 530 gas one.
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Took allot of weld but got the race out. Going to order bearings and seals for all 4 axles and two 10 foot 60h chains.
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Everyone online look like they weld a bead around the race and when it cools it will come right out. Going to give that a try..Then take...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Did you replace your bearing and race also? Was wondering what tool you got the race off with. I went to harbor freight and bought a...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Bought a tool that goes in the wrench and you put a breaker bar in that..Worked like a charm.Bearing came out in pieces..Inside bearing...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
It was actually catching on the plate underneath. Pried up a little and pulled right out. Stuck a wrench on the axle bolt and it wont...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
I have the 4 bolts out of the pump and it separated about an inch but wont come apart any farther? Has a hard stop like the shaft don't...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
I have lots of calipers. I have actually been a machinist for 36 years. Actually last 10 I am supervisor over brake form Dept and I do...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Do you know if the belly pan has a drain? Going to fix the axle seal and put new chains on and my oil in there is milky..
Also called...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Well I got the front pump valve thing off tonight. The book shows a o ring part #6519704 that should have been between them. There was...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
I was wondering if that would work..Thats great news.
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Looks like I am going to have yo take the front valve off that the steering rod goes through..Will never be able to get into the chains...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
I have to take two bolts out and hope my pump will raise up enough to let that plate come out. Does anything come out mounted to the...
-
Y
ymurf replied to the thread
1980 Bobcat 530.
This is the view of mine. My pump hangs over the back plate quite a bit. I hope I can get that plat off.
-
Y
ymurf replied to the thread
1980 Bobcat 530.
Thank you for the info..I have another question. I have front inspection plate off and took the bolt out of the brake arm but brake arm...