Recent content by Underachiever

The bushing in my tilt cylinder rod spun and is a little cracked on one end. I'm thinking about replacing it. Any tips or tricks to get the old one out and a new one in?

I just changed my case drain filters. I didn't have any way to cap off the the line from the hydro pump and I lost all the fluid from the pump, maybe a quart. Do I need to add fluid back into that pump somehow before I crank it back up? Any concerns I should have?

I've got a 753G that I'm looking to change out the hydraulic oil. I'm trying to determine what to put back in it. Right now I don't know what is in it. The service manual specifies Bobcat hydraulic fluid OR if not available a 10w-30 motor oil. I'd wager the BC brand hydro fluid is the right...

I'm planning to change the hydraulic fluid in my 753G. The service manual shows the reservoir holding 3.5 gallons and the total system as holding 6 gallons. The procedure in the manual says to pump out what's in the reservoir. That will leave 2.5 gallons in the system. Is there something else...

I tried to separate out my post above with paragraphs but it turned out like you see. If someone would like to edit it, it might be easier to read. Sorry about that.

S/N: 515833555 I need some troubleshooting guidance with my 753G. I'm not sure of the year. It has about 1950 hours. I've had it several years but haven't put many hours on it. Up until now it's been reliable. I tried to run it a few weeks ago and it cranked but wouldn't acknowledge the seat...