tech.35058's latest activity

I am not familiar with the lx565, but, isnt that a plug just above the level of the lower shaft on the left of the casing? I would...

Re quick attach ... Are you refering to the mounting plate for the bucket, or the hydraulic connectors? When i first got my lx865...

Greetings Don. I have an older, lx865, with similar, if not the same engine, i think. I have not personally replaced the lucas pump...

Did replacing the turbo cure the problem?

Look at where the pivot point would be. You have to move all of the cab weight, and a lot of the boom weight to get to the balance...

Pulling the seal off the core unit is a good plan. tipping the cab by pulling the loader frame ... I am not at all sure where the travel...

Pulling the seal off the core unit is a good plan. tipping the cab by pulling the loader frame ... I am not at all sure where the travel...

You are correct, if you are not dismantling the pump, you dont need that $500 seal kit. For a "getting paid to do it" job , we would...

one other thing, these new seals with the rubber like coating on the outer outer rim. you are supposed to lubricate the out side & just...

When I worked in the "old dyno", we would stand by with a rubber "board" to cover the turbo inlet on the first start up after a...

hours on my machine, gee, I don't know. hour meter is built into the "(electronic control thing)". I think mine is wonky, says something...