Help Support SkidSteer Forum:

M
Reaction score
1

Profile posts Latest activity Postings About Post areas

  • New guy here, I've had a 773 Bobcat for 3 weeks, I have put 3 hours on it with no problems. Now the machine will just randomly lock up and the "push to operate machine" lights go off. The green button does nothing at that point. I can use the over ride button to move the machine but the lift/tilt do nothing. Shut it off and wait 10-15 minutes and it will run a few more minutes. Codes says "None" any help appreciated.
    • Like
    Reactions: Daveb68
    T
    thedassler
    The reason I asked what kind of controllers you both have, is my t190 did something similar a few years back, except I was able to see a default code and that helped guide me in the right direction. My machine has dual controls, ACS, either foot and hand, or hand only (my preferred). Anyway, in my case it was a matter of the lift or tilt controller being out of calibration.
    T
    thedassler
    My problem was more serious and I spent a lot of time fine tuning my control units to solve the problem, only later to have the main control unit fail which I then replaced. If you look back on some of my threads, going back a few years, you might see what some of the other members wrote that helped me.
    M
    mocus250
    a friend had a similar problem with his, and it turned out the main computer was bad
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top