Recent content by farmer.palmer

Help Support SkidSteer Forum:

  1. F

    Clark Bobcat 300 perhaps 313

    @sLarsen Looking back at the belts I ordered I think they are the following; The shorter belt between the engine pulley and the oil pump is a SPZ 975 which goes on first. The longer belt (which sits above the SPZ 975 on the engine pulley and oil pump pulley) and then across to the gearbox...
  2. F

    Clark Bobcat 300 perhaps 313

    Happy to but it'll have to wait for a few weeks as I am away from the machine at the moment. Cheers
  3. F

    Clark Bobcat 300 perhaps 313

    Thanks for the reply. I sent you a reply via private message also to say I got this sorted by using two v-belts one on top of the other. Thanks again.
  4. F

    Clark Bobcat 300 perhaps 313

    Hi Sorry I did not see your reply unitl slarsen sent me an email and I checked in. Yes the pulleys are deep enough to run two belts. The bottom shorter belt runs from the engine pulley to the oil pump pulley, and the top longer belt runs in the same engine and oil pump pulley and onto the...
  5. F

    Bobcat Clark 300 Farmboy, Manual

    I have a parts book in PDF for the Bobcat 300 with the Kubota engine as above, happy to share it if anyone wants it. It's useful for exploded diagrams and such, but most parts are now obsolete from Bobcat. I am struggling to find the correct size of the V belts used on it, mine didn't have any...
  6. F

    Clark Bobcat 300 perhaps 313

    I don't have the shorter of the two belts on the machine. It was like this when I bought it. Thanks
  7. F

    Clark Bobcat 300 perhaps 313

    Hi I have recently purchased this old Clark Bobcat 300 machine which has been partially restored and seems to work ok. But I noticed the belt which runs from the engine to the chaincase input shaft and over the top of the oil pump gets very hot. The hydraulics seem very slow too so I tightened...
  8. bobcat 300 drive belts diagram.jpg

    bobcat 300 drive belts diagram.jpg

  9. F

    bobcat 310 manual

    Hi Sorry to resurrect an old thread but I don't suppose the 310 manual is still in circulation and would care to share it? Thanks in advance James ?
  10. F

    Sanderson Scorpion Skidsteer

    Is anybody familiar with the Scorpion in the UK? I have just bought a Bobcat 300 but also looking at buying a Sanderson Scorpion that's been offered locally, but I cannot find anything about them on the net. Any help appreciated...?
  11. F

    Hello from the UK - Devon

    Hi A newbie to skid steers, have just bought myself a Clark Bobcat 300, built in Japan according to the plate. This seems like a great resource, anybody else from the UK here?
Top