Recent content by Eston62

Ok, i`ll try to describe the protsess a little. First is reasnoable to find out if the solenoid has a problem There you can find 4 of them. Right side- 2 pc and left side two. They are located under cabine close to engine, there you can see this big pump unit with steering block`s, right and...

First of all, sorry for my English, it's a bit "faulty". Why was the hydraulic control valve replaced? It was the customer's request because the customer thought it was worn out. The customer is king you know :D . After the change, the hydraulic oil pressure was also checked and it was 210...

By "main hydraulic valve" i mean "HYDRAULIC CONTROL VALVE", sorry. The main relief valve is not always adjusted. Anyway, i was forced to check it because of this problem. I installed hydraulic control valve back into the machine yesterday. I also checked carefully if the hoses are installed...

Yes, pedals linkages are clean and correctly fixed, thank you.

I have S-300, high flow, two speed, bucket positioning. Main hydraulic valve were changed and there is a problem that no power in lift system when lifting up. Fluid lewel correct, lift cylinders are new. Other functions are working correctly. Main pressure 210 bar. The valves, working with lift...

I changed solenoid and adjusted via computer the central positsion of the swash plate. That's it.

If the weather is not warm there are no errors at all! The swash plate and the oil (HVLP 46) temperature- where is the connection ? Anyway, i tried the easy way- we just regulated the position of the swash plate using two buttons located on the top of the left joystick. If something else will...

Right now working with this problem...D7528... It started last summer with error of the solenoid. I changed it and during cold winter time it worked quite fine, no problems. Until last week..i changed left and right solenoids to find out if solenoid has some error but no, now the engine stops...