Thanks. Is there some preferred place on the block that I can remove a plug and replace with a fitting? I can see a plug on the thermostat housing that should work.
I have bought and installed a heating unit and hooked it up to the thermostat bypass but I can't seem to get any flow through the hoses even after pre-filling the unit. The hoses are long enough to allow the cab to be raised. Any ideas where I have gone wrong? Thanks
Thanks for the info and the link. It's just as everyone said PITA but doable. I could finally see the fittings and reach them with a wire brush to clean around them. I have an air grease gun from harbor freight for $20 and I think today it was worth every penny. I'm not sure when the machine was...
`I have recently bought a 1993 743B with a v2203 Kubota in it with 3100 hrs on the clock. I have read in other postings that this motor has more HP than the original and could overheat and damage the pump. Can anyone tell me how much more power the 2203 has than the v17or1902 and should I be...