Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Wanted a hydrostatic motor for a 700-720-721-722 Bobcat Skid Loader
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 74441" data-attributes="member: 82"><p>These motors only have 2 lines? the newer style have 3, 2 big ones, one small one.</p><p>How long was the machine run after the pump broke? I'd like to see at the very least the entire pump being pulled down and both motors stripped and cleaned. The pieces of foam down the hydraulic lines help push out any particles that may be in there.</p><p>When cleaning, you can use petrol/gas to wash the parts then blow down with compressed air. As the fuel dries without residue you can be sure it's clean. Re-assemble with lots of oil.</p><p>I'd drain the gearboxes too, just in case something got through the case drain hole. It's a good idea to clean out any goo from the gear wear that may be in there.</p></blockquote><p></p>
[QUOTE="Tazza, post: 74441, member: 82"] These motors only have 2 lines? the newer style have 3, 2 big ones, one small one. How long was the machine run after the pump broke? I'd like to see at the very least the entire pump being pulled down and both motors stripped and cleaned. The pieces of foam down the hydraulic lines help push out any particles that may be in there. When cleaning, you can use petrol/gas to wash the parts then blow down with compressed air. As the fuel dries without residue you can be sure it's clean. Re-assemble with lots of oil. I'd drain the gearboxes too, just in case something got through the case drain hole. It's a good idea to clean out any goo from the gear wear that may be in there. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Wanted a hydrostatic motor for a 700-720-721-722 Bobcat Skid Loader
Top