Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt cylinder wont hold position (853)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="ard" data-source="post: 57185" data-attributes="member: 7237"><p>Tazza, thanks for the answer. I already checked the wires from the sensor to the BOSS unit yesterday.</p><p>I had a little bit time after work today and removed the sensor. When i short the wires, BOSS no longer shows AF6 so the sensor switch has to be closed when engine is off. (As shown in the schematics).</p><p>Will try to get a new one tomorrow, lets hope that it is not to expensive. (They charged $30 for the spring at the steering spool only)</p></blockquote><p></p>
[QUOTE="ard, post: 57185, member: 7237"] Tazza, thanks for the answer. I already checked the wires from the sensor to the BOSS unit yesterday. I had a little bit time after work today and removed the sensor. When i short the wires, BOSS no longer shows AF6 so the sensor switch has to be closed when engine is off. (As shown in the schematics). Will try to get a new one tomorrow, lets hope that it is not to expensive. (They charged $30 for the spring at the steering spool only) [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt cylinder wont hold position (853)
Top