Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt cylinder wont hold position (853)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 57148" data-attributes="member: 82"><p>The sender could be bad, it should screw into the ait filter box where the hose goes to connect to the inlet manifold. It's essentially a vaccum switch. When it reaches a set value it turns on or off to tell the operator that the air filter(s) are causing too much of a restriction. I guess you could even have a bad connector/wire somewhere too....</p></blockquote><p></p>
[QUOTE="Tazza, post: 57148, member: 82"] The sender could be bad, it should screw into the ait filter box where the hose goes to connect to the inlet manifold. It's essentially a vaccum switch. When it reaches a set value it turns on or off to tell the operator that the air filter(s) are causing too much of a restriction. I guess you could even have a bad connector/wire somewhere too.... [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt cylinder wont hold position (853)
Top