Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
test for bad actuator and/or BICS controller
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Bobcatdan" data-source="post: 82144" data-attributes="member: 7339"><p>I would think the calibration proceeder would be basically the same, but would differ in some ways since the dash are different between F an G series. I can only think of a couple F series AHC I dealt with and I simply can't remember what or if I did a calibration on one. On a G series I never field calibrated since I had the laptop to run a acturator test/ calibrate. With AHC/ACS, calibration is only need for acturator replacement. Not need for sensors.</p></blockquote><p></p>
[QUOTE="Bobcatdan, post: 82144, member: 7339"] I would think the calibration proceeder would be basically the same, but would differ in some ways since the dash are different between F an G series. I can only think of a couple F series AHC I dealt with and I simply can't remember what or if I did a calibration on one. On a G series I never field calibrated since I had the laptop to run a acturator test/ calibrate. With AHC/ACS, calibration is only need for acturator replacement. Not need for sensors. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
test for bad actuator and/or BICS controller
Top