martinoamy
Member
- Joined
- Sep 18, 2022
- Messages
- 13
Any one 'suffer' from this?
I have checked the 120 ohm terminators on ends of each Can bus.
I have Can bus 0 and Can bus 1. Each have 2 terminators. Found the ones near the controllers to both be bad.
The way you tell on CB 0 is ohm between 3&4 pin at display should be 60 ohm.
120 ohms means one terminator bad. 0 ohm both bad.
Thought I would have it fixed with new terminators. Ohms are 60 at display but still have 'Loss of Communication between Display and Main Controller'.
I have not taken controllers out and check connections there. Will do today.
Any ideas?
I have checked the 120 ohm terminators on ends of each Can bus.
I have Can bus 0 and Can bus 1. Each have 2 terminators. Found the ones near the controllers to both be bad.
The way you tell on CB 0 is ohm between 3&4 pin at display should be 60 ohm.
120 ohms means one terminator bad. 0 ohm both bad.
Thought I would have it fixed with new terminators. Ohms are 60 at display but still have 'Loss of Communication between Display and Main Controller'.
I have not taken controllers out and check connections there. Will do today.
Any ideas?