Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S160 Fuel Solenoid Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Bobcatdan" data-source="post: 78603" data-attributes="member: 7339"><p>Always replace the relay when replacing the solenoid. I have been burned by that. Also make sure you are switching the right relay, the diagram on some can be a little difficult to orientate. Also check the wiring coming from the solenoid. I have seen quite a few rub and cause intermittent problems. Any problems with the solenoid and it should set a code. When it won't restart, pull the solenoid out. If that is the problem, the engine will start. You can snub the engine by running against the brake. I'd check to make sure the primer bulb isn't collapsing. This is a sign the engine is trying, but can't get fuel. I haven't seen it in a while, but had a rash of bad fuel caps not allowing the tank to vent.</p></blockquote><p></p>
[QUOTE="Bobcatdan, post: 78603, member: 7339"] Always replace the relay when replacing the solenoid. I have been burned by that. Also make sure you are switching the right relay, the diagram on some can be a little difficult to orientate. Also check the wiring coming from the solenoid. I have seen quite a few rub and cause intermittent problems. Any problems with the solenoid and it should set a code. When it won't restart, pull the solenoid out. If that is the problem, the engine will start. You can snub the engine by running against the brake. I'd check to make sure the primer bulb isn't collapsing. This is a sign the engine is trying, but can't get fuel. I haven't seen it in a while, but had a rash of bad fuel caps not allowing the tank to vent. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S160 Fuel Solenoid Problem
Top