Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Rebuilding a 1985 743 with a Kubota 1702 and i have a few questions.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Junkers" data-source="post: 128378" data-attributes="member: 23597"><p>I got enough of the 743 back together to get it started. I made a mess of every single fluid. These new fire proof fuel cans are a joke. I had to drill a vent hole in a new can just to get it to dispense fuel. After bleeding the fuel lines she starts right up and shot up to 2k rpm. I have a hand held tach. It appears someone screwed the throttle plate arm stops most of the way in. I unscrewed it back out and get about 800-900 rom at idle. The engine runs for a few seconds and dies. I think i still have air in the fuel system. Then i notice the engine bay filling up with oil. One of the hydraulic lines were loose on the top of the hydro unit. I got the line tight and gave up for today. My second person had to go home.</p></blockquote><p></p>
[QUOTE="Junkers, post: 128378, member: 23597"] I got enough of the 743 back together to get it started. I made a mess of every single fluid. These new fire proof fuel cans are a joke. I had to drill a vent hole in a new can just to get it to dispense fuel. After bleeding the fuel lines she starts right up and shot up to 2k rpm. I have a hand held tach. It appears someone screwed the throttle plate arm stops most of the way in. I unscrewed it back out and get about 800-900 rom at idle. The engine runs for a few seconds and dies. I think i still have air in the fuel system. Then i notice the engine bay filling up with oil. One of the hydraulic lines were loose on the top of the hydro unit. I got the line tight and gave up for today. My second person had to go home. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Rebuilding a 1985 743 with a Kubota 1702 and i have a few questions.
Top