Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
Bobcat Excavators
quick xchange mount for buckets
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="ffpup" data-source="post: 83272" data-attributes="member: 11563"><p>Yes I cut holes in the sides of the bucket and added washer like you said. Ill try and post some pictures in a few days. I am using the pin that is with the machine in the x-change. I used the pipe as the washers on each side. do a little measuring that I didn't do and cut holes in bucket off of the machine. You may have to do a little grinding on the inside of mounting bracket. Then hook and slide bucket on the xchange and make sure pin will slid in. Once you get it in and sliding free place 1/2 washer over each end of the pin and weld in a couple spots then remove from machine so you can flat weld washer on bucket. I hope you can understand my explanation.</p></blockquote><p></p>
[QUOTE="ffpup, post: 83272, member: 11563"] Yes I cut holes in the sides of the bucket and added washer like you said. Ill try and post some pictures in a few days. I am using the pin that is with the machine in the x-change. I used the pipe as the washers on each side. do a little measuring that I didn't do and cut holes in bucket off of the machine. You may have to do a little grinding on the inside of mounting bracket. Then hook and slide bucket on the xchange and make sure pin will slid in. Once you get it in and sliding free place 1/2 washer over each end of the pin and weld in a couple spots then remove from machine so you can flat weld washer on bucket. I hope you can understand my explanation. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
Bobcat Excavators
quick xchange mount for buckets
Top