Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No hydraulics
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="tomagregg" data-source="post: 77236" data-attributes="member: 3422"><p>I finally got the oil seals out of the motor carrier, thanks for the tip. On the side that was leaking badly the inside of the seal had been scraped away until it had worn a small hole through the metal. I assume whom ever installed the seal previously had set it in too far until it was touching the circlip. I would assume that the Seal could not move by it's self into that position. The manual states to install the seal with the seal driver until the seal driver bottoms out. Not having a factory seal driver, how far should I install the seal? There really isn't a shoulder for the seal to bottom out on. I want to make sure I don't put it in to deep or I'll have drill it out, remove it, and buy a new seal again.</p></blockquote><p></p>
[QUOTE="tomagregg, post: 77236, member: 3422"] I finally got the oil seals out of the motor carrier, thanks for the tip. On the side that was leaking badly the inside of the seal had been scraped away until it had worn a small hole through the metal. I assume whom ever installed the seal previously had set it in too far until it was touching the circlip. I would assume that the Seal could not move by it's self into that position. The manual states to install the seal with the seal driver until the seal driver bottoms out. Not having a factory seal driver, how far should I install the seal? There really isn't a shoulder for the seal to bottom out on. I want to make sure I don't put it in to deep or I'll have drill it out, remove it, and buy a new seal again. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
No hydraulics
Top