Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
M-610 tilt cylinder replace or remanufacture?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="rjardo" data-source="post: 86480" data-attributes="member: 9710"><p>Thanks again Jerry, i did find new glands for $157 each, i'll check it closely when i get it apart. i think the leak is due to some deep scratches near the end of the rod.. it drips after i shut down, but if i dump the bucket over so the rod is extended 4-5 inches, it doesn't drip as much.. Hopefully i can catch it before the gland is damaged too much, and JB will stand up to the transmission fluid for a couple of years..</p></blockquote><p></p>
[QUOTE="rjardo, post: 86480, member: 9710"] Thanks again Jerry, i did find new glands for $157 each, i'll check it closely when i get it apart. i think the leak is due to some deep scratches near the end of the rod.. it drips after i shut down, but if i dump the bucket over so the rod is extended 4-5 inches, it doesn't drip as much.. Hopefully i can catch it before the gland is damaged too much, and JB will stand up to the transmission fluid for a couple of years.. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
M-610 tilt cylinder replace or remanufacture?
Top