Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
GEHL Skidsteer Forum
Gehl 2500 Jerking???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="lastcast" data-source="post: 78229" data-attributes="member: 11214"><p>Greetings All: Have an old Gehl 2500 skidsteer. Recently it has occasionally started jerking and shaking when you go forward with the t control. It shakes pretty bad and kinda makes grinding noise, then will stop if I go back to netural position. It does this without notice and was wondering what might be causing this? Will low hydro fluid or air in lines cause this shaking and bucking? I did add hydro fluid a while back and was wondering if it might need more to stop this from happening?, or need to bleed air from lines? Very hard to read hydro fluid dipstick and very hard to fill due to small opening on top where dip stick stick comes unscrews from. BTW: Was using loader today and guess what? Cylinder on left side that lifts bucket arms blew the seal and sprayed me good with hydro fluid. Murphys Law!!! Any help with the bucking is greatly appreciated. Look forward to your replies. Regards: Lastcast</p></blockquote><p></p>
[QUOTE="lastcast, post: 78229, member: 11214"] Greetings All: Have an old Gehl 2500 skidsteer. Recently it has occasionally started jerking and shaking when you go forward with the t control. It shakes pretty bad and kinda makes grinding noise, then will stop if I go back to netural position. It does this without notice and was wondering what might be causing this? Will low hydro fluid or air in lines cause this shaking and bucking? I did add hydro fluid a while back and was wondering if it might need more to stop this from happening?, or need to bleed air from lines? Very hard to read hydro fluid dipstick and very hard to fill due to small opening on top where dip stick stick comes unscrews from. BTW: Was using loader today and guess what? Cylinder on left side that lifts bucket arms blew the seal and sprayed me good with hydro fluid. Murphys Law!!! Any help with the bucking is greatly appreciated. Look forward to your replies. Regards: Lastcast [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
GEHL Skidsteer Forum
Gehl 2500 Jerking???
Top