Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building my bobtach
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 52806" data-attributes="member: 82"><p>Nice job, the way i did mine was slightly different. I had to cut those bosses out as they were really worn. I made new ones and installed everything including the pins in the arms, the pins held the bosses straight, i then welded the bosses into place. The pins did a good job holding the bosses straight. They did move a little bit when i took the bobtach off and welded around the ends to give it a good join. Taking a little off the bushings fixed the small amount of binding it had. I think i left my tollerences too tight in the first place, not allowing quite enough clearance for the grease, i think it was only .005 to .008"</p></blockquote><p></p>
[QUOTE="Tazza, post: 52806, member: 82"] Nice job, the way i did mine was slightly different. I had to cut those bosses out as they were really worn. I made new ones and installed everything including the pins in the arms, the pins held the bosses straight, i then welded the bosses into place. The pins did a good job holding the bosses straight. They did move a little bit when i took the bobtach off and welded around the ends to give it a good join. Taking a little off the bushings fixed the small amount of binding it had. I think i left my tollerences too tight in the first place, not allowing quite enough clearance for the grease, i think it was only .005 to .008” [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building my bobtach
Top