Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building a 3-point adapter and PTO for Bobcats
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 77317" data-attributes="member: 931"><p>The relief and would have to be on the return side of the motor and bypass back to the intake side as when you shut the supply off the motor will operate as a pump from the centrifugal force of the cutter wheel. If the flow control would be on the supply hose only it won't relieve the pressure between the motor and the aux valve or solenoid. I think there are photos of this setup in the media section/</p></blockquote><p></p>
[QUOTE="jerry, post: 77317, member: 931"] The relief and would have to be on the return side of the motor and bypass back to the intake side as when you shut the supply off the motor will operate as a pump from the centrifugal force of the cutter wheel. If the flow control would be on the supply hose only it won't relieve the pressure between the motor and the aux valve or solenoid. I think there are photos of this setup in the media section/ [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building a 3-point adapter and PTO for Bobcats
Top