Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building a 3-point adapter and PTO for Bobcats
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Dameon" data-source="post: 76184" data-attributes="member: 10703"><p><a href="https://www.skidsteerforum.com/DesktopDefault.aspx?tabid=54&frmView=ShowPost&PostID=65656" target="_blank"><u>This thread</u></a> was a good start to a worthy project, but kind of died out and didn't have much information for a DIYer like me.</p><p>Surplus Center has this nice set of <a href="http://www.surpluscenter.com/Tech-Help/Tech-Help-Home/" target="_blank"><u>calculators</u></a>, but the one referenced in the other thread seems to be AWOL. I needed to calculate what pump would work on a high flow 733 (27 gpm) to output a 540 rpm shaft speed.</p><p>I could always go spent $2K on a pre-built adapter/mount, but I don't have $2K to invest in this project. I think I could build a nice setup for $300 or less.</p></blockquote><p></p>
[QUOTE="Dameon, post: 76184, member: 10703"] [URL='https://www.skidsteerforum.com/DesktopDefault.aspx?tabid=54&frmView=ShowPost&PostID=65656'][U]This thread[/U][/URL] was a good start to a worthy project, but kind of died out and didn't have much information for a DIYer like me. Surplus Center has this nice set of [URL='http://www.surpluscenter.com/Tech-Help/Tech-Help-Home/'][U]calculators[/U][/URL], but the one referenced in the other thread seems to be AWOL. I needed to calculate what pump would work on a high flow 733 (27 gpm) to output a 540 rpm shaft speed. I could always go spent $2K on a pre-built adapter/mount, but I don't have $2K to invest in this project. I think I could build a nice setup for $300 or less. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Building a 3-point adapter and PTO for Bobcats
Top