Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bradco 11 MD2 backhoe attachment brackets ??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="monumental" data-source="post: 40972" data-attributes="member: 5109"><p>Thank you both for the suggestions. Last night I looked a little closer at the existing brackets and my machine. I took some measurements and as it is right now the brackets will not fit inbetween my bucket cylinders. The outside measurements of the brackets is 23-1/4" . I have 21-1/4" between the cylinders and I guess I should have at least 1/2" clearance on each side. So it may be possible to modify the existing brackets by moving the arms inward 1-1/2" each side. Once I cut the arms off the brackets I can hook the backhoe attachment up to the machine and see if I have to modify the length of the arms. It looks like these brackets mount on a horzintal rod pin. I've never actually seen one hooked up but I can visulize it. Can you post pictures on this forum ? If so I can show you what it looks like.</p></blockquote><p></p>
[QUOTE="monumental, post: 40972, member: 5109"] Thank you both for the suggestions. Last night I looked a little closer at the existing brackets and my machine. I took some measurements and as it is right now the brackets will not fit inbetween my bucket cylinders. The outside measurements of the brackets is 23-1/4" . I have 21-1/4" between the cylinders and I guess I should have at least 1/2" clearance on each side. So it may be possible to modify the existing brackets by moving the arms inward 1-1/2" each side. Once I cut the arms off the brackets I can hook the backhoe attachment up to the machine and see if I have to modify the length of the arms. It looks like these brackets mount on a horzintal rod pin. I've never actually seen one hooked up but I can visulize it. Can you post pictures on this forum ? If so I can show you what it looks like. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bradco 11 MD2 backhoe attachment brackets ??
Top