Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 service manual desperately needed and will it turn over if one glow plug is broken off and cant be removed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 79868" data-attributes="member: 82"><p>I agree to not worry too much about the wiring just yet.</p><p>Ensure you have coolant in the radiator first.</p><p>As i mentioned in my email, lift the wheels up, turn the brake off, prime injector pump, ensure the stop cable is not pulled and the arm is not in the stop position under the pump. Crack nuts at injectors then crank with a jumper from the big +ve cable from the starter to the small pin on the starter solenoid till you get fuel at the injectors. Tighten the tube lines then see if you get white smoke.</p><p>If it smokes, you are getting fuel. Hook up the remaining glow plugs with a heave wire to the +ve battery terminal for 30-60 seconds and crank again, see if it fires. WHen going disconnect the plugs.</p></blockquote><p></p>
[QUOTE="Tazza, post: 79868, member: 82"] I agree to not worry too much about the wiring just yet. Ensure you have coolant in the radiator first. As i mentioned in my email, lift the wheels up, turn the brake off, prime injector pump, ensure the stop cable is not pulled and the arm is not in the stop position under the pump. Crack nuts at injectors then crank with a jumper from the big +ve cable from the starter to the small pin on the starter solenoid till you get fuel at the injectors. Tighten the tube lines then see if you get white smoke. If it smokes, you are getting fuel. Hook up the remaining glow plugs with a heave wire to the +ve battery terminal for 30-60 seconds and crank again, see if it fires. WHen going disconnect the plugs. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 service manual desperately needed and will it turn over if one glow plug is broken off and cant be removed
Top