Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 632 shutdown
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="coreya3212" data-source="post: 24634" data-attributes="member: 2406"><p>I think I may have found my problem. After tazza said maybe a lazy lift pump, I went back tot he tank to check my pick up and discharge line. Then i went to test the lift pump. When i pull off the suction line, there is a piece between the line and the pump, Is this a check valve? It has a ball and spring inside anyway. That was all full of junk. I cleaned it out and tested the pressure which I guess to be bewtween 5 and 6 psi. Dacott, if it helps, my service manual states that lift pump pressure should be a minimun of 4.5 psi, so I would figure you are in the range as well. You may want to check the lines and check valve as well. I dont know for sure if I found my issue as I havent run it enough to find out, but for a short spin, it actually seems to run a little smoother.</p></blockquote><p></p>
[QUOTE="coreya3212, post: 24634, member: 2406"] I think I may have found my problem. After tazza said maybe a lazy lift pump, I went back tot he tank to check my pick up and discharge line. Then i went to test the lift pump. When i pull off the suction line, there is a piece between the line and the pump, Is this a check valve? It has a ball and spring inside anyway. That was all full of junk. I cleaned it out and tested the pressure which I guess to be bewtween 5 and 6 psi. Dacott, if it helps, my service manual states that lift pump pressure should be a minimun of 4.5 psi, so I would figure you are in the range as well. You may want to check the lines and check valve as well. I dont know for sure if I found my issue as I havent run it enough to find out, but for a short spin, it actually seems to run a little smoother. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 632 shutdown
Top