Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 632 shutdown
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 24566" data-attributes="member: 931"><p>the wire may be hidden by crud but it should be there and a clip connector about 6 inches from the carb. I had to take the carb off to work on it which is not a big deal just take the fuel line off at the pump, undo the governor rod at the first joint is easier than at the carb,you will have to take the nut off to undo the rod they do not have a spring release, release the choke wire and take out the two flange bolts that hold it on, one comes down thru from the top of the manifold. when you put it back on do not over tighten them as it is easy to strip the threads out of the carb flange. I had to helicoil one of the bolt holes but I think it was mostly bad to begin with. disconnect the battery also, with all that gas splashed around you don't want any sparks from wrenchs.</p></blockquote><p></p>
[QUOTE="jerry, post: 24566, member: 931"] the wire may be hidden by crud but it should be there and a clip connector about 6 inches from the carb. I had to take the carb off to work on it which is not a big deal just take the fuel line off at the pump, undo the governor rod at the first joint is easier than at the carb,you will have to take the nut off to undo the rod they do not have a spring release, release the choke wire and take out the two flange bolts that hold it on, one comes down thru from the top of the manifold. when you put it back on do not over tighten them as it is easy to strip the threads out of the carb flange. I had to helicoil one of the bolt holes but I think it was mostly bad to begin with. disconnect the battery also, with all that gas splashed around you don't want any sparks from wrenchs. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 632 shutdown
Top