Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Almost impossible to start deutz in bobcat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="sstec" data-source="post: 81606" data-attributes="member: 5862"><p>Mike, The first time I did mine by the Bobcat Manual..... Ran the same with smoke, researched until I found EPU, called them, talked to Ron. rented their tool kit, (i already had the pins ). They sent the 9 pages of deutz instructions. Ron gave me his cell # and said to call if I had any questions. Which I did... after re-reading their 9 pages verse bobcat 1/2 page, replaced pushrods and rocker arm bolts per EPU guidelines. Set proper tension with gage provided. I'm a believer, runs ways better then it ever did, fuel consumption went way down and better power. Mine was off by one tooth on the crank, who ever did it before I owned it, had it replaced and traded it in shortly after. Don't loose hope, it can be fixed. sstec</p></blockquote><p></p>
[QUOTE="sstec, post: 81606, member: 5862"] Mike, The first time I did mine by the Bobcat Manual..... Ran the same with smoke, researched until I found EPU, called them, talked to Ron. rented their tool kit, (i already had the pins ). They sent the 9 pages of deutz instructions. Ron gave me his cell # and said to call if I had any questions. Which I did... after re-reading their 9 pages verse bobcat 1/2 page, replaced pushrods and rocker arm bolts per EPU guidelines. Set proper tension with gage provided. I'm a believer, runs ways better then it ever did, fuel consumption went way down and better power. Mine was off by one tooth on the crank, who ever did it before I owned it, had it replaced and traded it in shortly after. Don't loose hope, it can be fixed. sstec [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Almost impossible to start deutz in bobcat
Top