Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
963g bics blowing fuses
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Pickuptrck" data-source="post: 78291" data-attributes="member: 11165"><p>BICS gave 6 flashes for the traction lock (lift and tilt is solid green and operating) so I installed a new solenoid from bobcat on the aluminum splitter block, left side, straight under the seat. No luck =( Still 6 flashes, maintenance book shows short to ground. There are 2 solenoids on this block and I'd love to just eliminate it all together. The sides of the block are marked "P" on the right side with a hyrdo line going towards the hydro pump area, a T fitting with 2 lines and a stamped letter (A or B, I forget which) that appear to run to the wheel motors,then 2 single reurn lines leading to a capped solenoid on the machine wall and the other tees into the hydro tank return. My question is can I simply let BICS blink and get it moving for a week by Teeing the line on "P" to the Tee fitting with 2 lines off of it to jumper the park barke off. After a week, I' will be able to take this machine down fro months, right now I need it moved though. can the solenoid and its plunger be removed on the high pressure side then the port plugged to finish this job? I would be happier spending $2k to replace every solenoid with throw handles.</p></blockquote><p></p>
[QUOTE="Pickuptrck, post: 78291, member: 11165"] BICS gave 6 flashes for the traction lock (lift and tilt is solid green and operating) so I installed a new solenoid from bobcat on the aluminum splitter block, left side, straight under the seat. No luck =( Still 6 flashes, maintenance book shows short to ground. There are 2 solenoids on this block and I'd love to just eliminate it all together. The sides of the block are marked "P" on the right side with a hyrdo line going towards the hydro pump area, a T fitting with 2 lines and a stamped letter (A or B, I forget which) that appear to run to the wheel motors,then 2 single reurn lines leading to a capped solenoid on the machine wall and the other tees into the hydro tank return. My question is can I simply let BICS blink and get it moving for a week by Teeing the line on "P" to the Tee fitting with 2 lines off of it to jumper the park barke off. After a week, I' will be able to take this machine down fro months, right now I need it moved though. can the solenoid and its plunger be removed on the high pressure side then the port plugged to finish this job? I would be happier spending $2k to replace every solenoid with throw handles. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
963g bics blowing fuses
Top