Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
'89 Bobcat 743 control valve
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 77766" data-attributes="member: 82"><p>Ok, now i see what you mean.</p><p>The valves i have done all had an internal groove machined into them so you had to use the quad rings to seal it. Does your control block have the long chamfer like what is shown in the manual? if so, it does sound like the lip seal is what you need.</p><p>If you look at the two pages up from the last one where it shows the lip seal, you will see one has a parallel hole with a short chamfer, then one with a notch. The notch style is the one i have always encountered.</p><p>It may just be a valve like i have not seen before, if all the diagrams agree and the lip seal is what is meant to go in there, you are doing it the right way already.</p></blockquote><p></p>
[QUOTE="Tazza, post: 77766, member: 82"] Ok, now i see what you mean. The valves i have done all had an internal groove machined into them so you had to use the quad rings to seal it. Does your control block have the long chamfer like what is shown in the manual? if so, it does sound like the lip seal is what you need. If you look at the two pages up from the last one where it shows the lip seal, you will see one has a parallel hole with a short chamfer, then one with a notch. The notch style is the one i have always encountered. It may just be a valve like i have not seen before, if all the diagrams agree and the lip seal is what is meant to go in there, you are doing it the right way already. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
'89 Bobcat 743 control valve
Top